Reconfiguring DTS on Nodes
DTS is initially configured during the overall DCE configuration procedure for a node (see OSF DCE Administration Guide - Introduction). The DCE configuration procedure automatically creates and activates DTS servers and DTS clerks on designated nodes. You can, however, reconfigure DTS on a node at any time. If you choose to do this, you must perform the following steps:
1. Stop the clerk or server process (DTS daemon) that is currently executing on the node.
2. Run the dce_config script to restart the DTS daemon on the node as a clerk or server.
3. Set any clerk or server attribute values as needed.
The following subtopics provide detailed instructions for performing each of the reconfiguration steps listed above.
More:
Stopping an Existing Clerk or Server
Creating a New Clerk or Server
Setting Clerk and Server Attribute Values