; To add support for a new modem, you can either make changes to existing
;   lines at the end of this file, or add a new line.  If you add a new line,
;   you must increment the number just above the lines.  Each line must
;   contain the following 8 items, each separated only by the symbol ^.
;
; Modem Name
;   Up to 80 characters in length.
;
; Maximum Speed
;   The maximum baud rate that your modem can accept commands.
;
; Modem Initialization String
;   Commands that will be used to configure the modem before dialing.
;
; Second Modem Initialization String
;   Enter a second (or third, etc.) modem initialization string only if
;   your modem requires more configuration commands than the modem can
;   accept in a single string.
;
; Third Modem Initialization String
;   See above.
;
; Fourth Modem Initialization String
;   See above.
;
; Connect Message:
;   The message your modem displays when it establishes a connection.
;
; Flow control:
;   Must be 1 for modems that use hardware flow control (CTS/RTS) or 2 for
;   software flow control.
;
; Reserved value:
;   Must be zero.
;
; This line and all lines above are comments. The lines below are modem data.
7
Direct Connect (Cabled)^115200^^^^^^2^1
Hayes compatible 1200^1200^ATE1V1Q0S0=0^^^^^2^0
Hayes compatible 2400^2400^ATE1V1Q0S0=0S11=55&C1&D2^^^^^2^0
Hayes compatible high-speed^19200^AT&FE1V1Q0L0&C1&D2&K3S11=55S38=0S95=2^^^^^1^0
User defined highspeed^38400^AT&FE1V1Q0X4&C1&D2&K3&R0S11=40S38=0S95=3^^^^CONNECT^1^0
User defined low speed^2400^ATE1V1Q0S0=0S11=55&C1&D2^^^^CONNECT^2^0
IBM 7851 14.4^14400^AT&F^AT&C1&D2&K3&Q5^^^CONNECT^1^0