OSINAPM - TRAP000D AFTER INSTALLING OS/2 2.11 OR OS/2 WARP ON A
          NON-IBM SYSTEM
01/29/96

=======================================================================
 TRAP000D after Installing OS/2 2.11 or OS/2 Warp on a Non-IBM System
=======================================================================

Please Read Entire Document for Full Explanation of Procedures
--------------------------------------------------------------

DESCRIPTION

When restarting the system after installing OS/2 2.11 MR1 or OS/2 Warp 
3.0, the following message is received:

   TRAP000D CS:EIP=0768:00000011 CSLIM=0000ffff

RESOLUTION

Note: Make sure you have a backup of any file you intend to change.

Currently, non-IBM clones with Advanced Power Management (APM) features 
are not compatible with APM drivers under OS/2. 

If this message is received after a full installation, check the CMOS 
and disable any APM options that are set. (System boards are not tested 
for APM.) If the CMOS does not have APM support, edit the CONFIG.SYS 
file and remark-out (REM) the following statements (x is the drive 
where OS/2 is installed):

* OS/2 Warp:

     DEVICE=x:\OS2\BOOT\APM.SYS
     DEVICE=x:\OS2\MDOS\VAPM.SYS

* OS/2 2.11:

     DEVICE=x:\OS2\APM.SYS
     DEVICE=x:\OS2\MDOS\VAPM.SYS

Save and exit the CONFIG.SYS file, and then restart the system to 
activate the changes.

______________________________________________________________________
IBM disclaims all warranties, whether express or implied, including 
without limitation, warranties of fitness and merchantability with 
respect to the information in this document. By furnishing this 
document, IBM grants no licenses to any related patents or copyrights.  
Copyright (c) 1994, 1996 IBM Corporation. Any trademarks and product 
or brand names referenced in this document are the property of their 
respective owners. Consult your product manuals for complete trademark 
information.