OSMKPCMS - ADDING PCMCIA SUPPORT AFTER INSTALLATION OF OS/2 WARP
01/24/96

=======================================================================
        Adding PCMCIA Support after Installation of OS/2 Warp
=======================================================================

Please Read Entire Document for Full Explanation of Procedures
--------------------------------------------------------------

DESCRIPTION

This document describes how to add PCMCIA support after installing OS/2 
Warp.

RESOLUTION

1. Open OS/2 System.

2. Open System Setup.

3. Select Selective Install.

4. Select PCMCIA Support from the System Configuration window.

5. Select the appropriate system (this should be either a direct match
   with your target installation system or a known compatible system).

6. Select OK.  

7. Select the type of PCMCIA support to be installed. If the PCMCIA
   device is other than a fax/modem, hard disk, or Flash memory device,
   additional device drivers will be needed. Refer to the installation
   instructions that came with the PCMCIA device.

8. When the System Configuration window reappears, select OK.

9. Select Install; then follow the instructions on the screen.

______________________________________________________________________
IBM disclaims all warranties, whether express or implied, including 
without limitation, warranties of fitness and merchantability with 
respect to the information in this document. By furnishing this 
document, IBM grants no licenses to any related patents or copyrights.  
Copyright (c) 1994, 1995 IBM Corporation. Any trademarks and product 
or brand names referenced in this document are the property of their 
respective owners. Consult your product manuals for complete trademark 
information.