OSVIWEP9 - SETTING UP THE WEITEK P9000 AND P9100 FOR OS/2 WARP
01/26/96

=======================================================================
         Setting Up the Weitek P9000 and P9100 for OS/2 Warp
=======================================================================

Please Read Entire Document for Full Explanation of Procedures
--------------------------------------------------------------

DESCRIPTION

Only VGA resolution is available, or WIN-OS/2 cannot be used in high 
resolution.

RESOLUTION

Important: The following steps must be performed in the sequence 
presented; otherwise, the procedure won't work, and your problem won't 
be resolved.

 1. Open OS/2 System.

 2. Open System Setup.

 3. Open Selective Install.

 4. Select Primary Display.

 5. When Weitek P9000 or Weitek P9100 is highlighted, press V on the
    keyboard. Video Graphics Array (VGA) will be highlighted.

 6. Click on OK; then click on OK again.

 7. At the Installation screen, highlight WinOS2 Support and OS/2 DOS
    Support; then click on Install.

 8. Shut down and then restart the system.

 9. Open OS/2 System.

10. Open System Setup.

11. Open Selective Install.

12. Select Primary Display.

13. Weitek P9000 or Weitek P9100 should be highlighted. Click on OK.

14. Click on OK again; then select Install.

15. Select DEFAULT monitor type and finish the installation.

16. Shut down and then restart the system.

17. Open OS/2 System.

18. Open System Setup.

19. Open System.

20. Select 1024x768x65536 or desired resolution.

21. Close the window.

22. Shut down and then restart the system.

23. Open a WIN-OS/2 Full Screen session.

24. Click on File and then Run...; then type C:\WINDOWS\P91INST.EXE and
    click on OK. P91INST.EXE is an installation program. Do not change
    any settings except to change 60 Hz to 70 Hz.

25. Click on OK and restart Windows; then exit Windows.

26. At the Desktop:

    a. Open OS/2 System.
    b. Open Command Prompts.
    c. Select OS/2 Window.

27. Type x:\OS2\POWER_9K\P9CNFG.EXE and press Enter (x is the drive
    where OS/2 Warp is installed). Do not make any changes except to
    change the refresh rate from 60 Hz to 70 Hz.

28. Click on OK to save; then shut down and restart the system.

Note: Steps 14 through 22 must be performed for each resolution
      you desire to use.

Your system should start OK. If the fonts are smaller than you like:

1. Move the mouse pointer to an empty spot on the Desktop and click the
   right mouse button.

2. Select Settings and then Change font... .

3. Select the desired font in the Name and Size fields.

4. Close the Settings notebook.

______________________________________________________________________
IBM disclaims all warranties, whether express or implied, including 
without limitation, warranties of fitness and merchantability with 
respect to the information in this document. By furnishing this 
document, IBM grants no licenses to any related patents or copyrights.  
Copyright (c) 1994, 1996 IBM Corporation. Any trademarks and product 
or brand names referenced in this document are the property of their 
respective owners. Consult your product manuals for complete trademark 
information.