VIRTUAL POINT to POINT ADAPTER Driver for Windows NT v1.0.1 Update ------------- Extract Files ------------- Create a directory on your hard drive and copy the the self extracting file VPPA101.exe into the directory. From the directory run VPPA101.exe which extracts the installation files for the VPPA101 update. ******************************************************* * NOTE: * * If you already have the VPPA software installed, * * see the UPDATE section below. * ******************************************************* ------------ Installation ------------ Installation is accomplished using the standard Windows NT adapter installation process. I.E. Go to Network Properties, click on the "Adapters" tab, and select "Add". Use the "Have Disk" button and specify a path to the VPPA installation directory. This product requires that the ESCON DRIVERS for Windows NT be installed. VPPA configuration parameters will be required during the installation process. ------ Update ------ If you already have the VPPA software installed, it is NOT necessary to uninstall and then reinstall the software. To update the software, go to Network Properties, click on the "Adapters" tab. Select the Virtual Point to Point Adapter, and select "Update". Specify a path to the VPPA update directory and click "Continue". You must repeat the UPDATE procedure for each VPPA installed in the system.