How do I install the Diamond Stealth 64 VRAM card in OS/2 Warp? You can install the Diamond version 1.0 drivers successfully in OS/2 2.1; however, installing the drivers in Warp causes a Device Select Code (DSC) fault configuration. The following is the correct installation procedure for Warp: 1. Insert disk #1 from Diamond into the A: drive. 2. Open an OS/2 window and type A: (press Enter). 3. Type S3INST A: C: (C: is the drive that contains OS/2.) 4. The files are installed for you and then you are prompted to install disk #2. When finished, shut down OS/2. 5. After restarting the system, open an OS/2 window. At the C: prompt type: CD\OS2\INSTALL (press Enter). 6. Rename WP9100.DSC to WP9100.ERR, rename WP9000.DSC to WP9000.ERR. 7. Restore the file saved by the driver installation as follows: C:\OS2\INSTALL>COPY DSPINSTL.SAV DSPINSTL.EXE (press Enter) 8. To change the SVGA resolutions and color depths open SYSTEM SETUP and select the SYSTEM object. Change the display to a resolution you wish to run, then shut down and the new display will be in effect for WINOS2 and OS/2 Warp. If you have any questions about this procedure, please post a note in the appropriate topic or forum area. Be sure to include your OS version and your model number (i.e., 2155-G82).