H017452 - SECONDARY IDE PORT NOT PRESENT AFTER WIN95 REBOOT SYMPTOM: IBM PC 340 Series 6560 with Windows95 installed may not recognize any IDE devices installed on the secondary IDE port on the system board after removing the IDE controller from the Windows95 Device Manager and rebooting the system. PROBLEM ISOLATION AIDS: If the IDE controller is inadvertently removed via the Device Manager in Windows95 and the system is rebooted, the Install Wizard may not properly detect the secondary IDE controller on the system board. Any device installed on that port, whether configured for Primary or Slave, will not be recognized. Viewing the IDE controller via the Device Manager will only show the presence of one IDE controller (Primary controller single FIFO). FIX: A fix has been developed to allow Windows95 to properly identify the IDE controller on the PC 340 system board. This file will prevent this failure from occuring and restore the secondary controller in systems that are exhibiting this symptom. Obtain and install IDE340FX.EXE from the IBM PC Company BBS. The file may be obtained from the IBM PC Company BBS system by calling 1-919-517-0001. View the "IBM PC 300/700 Files" section (section #21) for the file titled: IDE340FX.EXE - Patch for Win95 IDE Issues on 6560 The file may also be downloaded via the Internet from the IBM Personal Computer File Library by searching the following Internet URL: http://www.pc.ibm.com/files.html View the README file for installation instructions. Windows95 is a trademark of the Microsoft Corporation.