H16253:  2635 HDD SPACER RELEASED FOR USE WITH 12.5MM HDDS                     
                                                                                
 TEXT:                                                                          
 The Hard Disk Drive Bracket FRU P/N73H9936 can accommodate an HDD              
 of 17mm and 12.5mm.  A spacer must be used with the 12.5mm high                
 HDD. The Spacer and spacer installation instructions are included              
 with the HDD bracket FRU.  This FRU must be ordered if a 2.1GB                 
 12.5mm HDD is received as a replacement FRU for a 2.1GB 17mm                   
 HDD.                                                                           
                                                                                
                  _____________________                                         
                 /                    /| <---Spacer tabs                        
                /  ( )  ( )  ( )  ( )/|/                                        
               /      ( )  ( )  ( ) /                                           
              / ( )  ( )  ( )  ( ) /<-----Spacer                                
             /____________________/|                                            
             /                   |/                                             
  HDD ----> /___________________/  /                                            
  Connector |                   | /<-----12.5mm 2.1GB HDD                       
            |___________________|/                                              
                                                                                
  1. Place the HDD spacer on the HDD (Note: the spacer tabs                     
     should be on the side opposite the HDD connector.)                         
                                                                                
  2. Install the HDD and spacer assembly into the bracket.                      
                                                                                
  3. Attach the HDD and spacer assembly to the bracket using                    
     screws removed from the old HDD.                                           
                                                                                
  4. Install the complete HDD bracket assembly into the ThinkPad                
     making sure the connector is fully seated.                                 
                                                                                
 This information will be included in the on-line Hardware                      
 Maintenance Manual (HMM) and in the next revision of the                       
 hardcopy HMM.