H16452 - PC SERVER 720: INSTALLING LONG ADAPTERS TEXT: It is important to adjust the two card guides (which are independent from each other) when installing long adapters. Improper adjustment and/or installation of the card guides can cause long adapters to be improperly seated. This can cause the adapter to pop up on one end causing intermittent errors and hangs. Be sure to review pages 72 to 75 of the PC Server 720 User's Handbook entitled "Installing Long Adapters". Reviewing these pages will ensure proper installation of adapters. Refer to the five(5) diagrams on page 74: They are referenced below as TOP LEFT, TOP RIGHT, CENTER, BOTTOM LEFT, and BOTTOM RIGHT. TOP LEFT - This diagram shows how to remove the card guide from the system for adjustment. There are two card guides per system and each card guide can be adjusted independent of the other one. TOP RIGHT - This diagram shows the two possible locations for re-installing the card guides if the length of the card changed but the width did not. The CENTER, BOTTOM LEFT, and BOTTOM RIGHT diagrams show the adjustment of the card guide to accommodate adapters of different widths. CENTER - This diagram shows how to position each slot of the card guide. Each card guide has 4 individual adjustable retainers. These retainers snap/unsnap for removal/installation and can be adjusted for different widths as shown in the BOTTOM LEFT and BOTTOM RIGHT diagrams. BOTTOM LEFT - This diagram shows how to separate the individual position retainer into its component pieces. The pieces are held together by snaps and this diagram shows how to unsnap them. BOTTOM RIGHT - This diagram shows a position retainer separated into its component pieces. The arrow in the diagram shows how to resnap the component pieces to accommodate adapters of different widths. July 16, 1997